Canon PIXMA MX922 설정 매뉴얼 - 페이지 3
{카테고리_이름} Canon PIXMA MX922에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon PIXMA MX922 31 페이지. Getting your multifunction
back on your network
after a router or network change
Canon PIXMA MX922에 대해서도 마찬가지입니다: 간편한 설정 (2 페이지), 네트워크 설정 매뉴얼 (21 페이지), 설정 (29 페이지), 연결 설정 (15 페이지), 빠른 매뉴얼 (22 페이지), 매뉴얼 (20 페이지)
페이지 인쇄
Network Connection
Wireless Connection
a Preparation for Connection
Before Starting Wireless Connection Setup
1. Make sure that the printer is turned on.
If the power is on, a button on the Operation Panel (A) is lit.
Notes on Wireless Connection
•
Make sure that the computer is connected to the access point (A) (or wireless network router) you want to connect your
printer to. For details on how to check the settings, refer to the manual supplied with the router or contact its manufacturer.
The confi guration, router functions, setup procedures and security settings of the network device vary depending on your
•
system environment. For details, refer to the manual of your network device or contact its manufacturer.
Check if your device supports IEEE802.11n (2.4 GHz), IEEE802.11g or IEEE802.11b.
•
•
If your device is set to the "IEEE802.11n only" mode, WEP or TKIP cannot be used as a security protocol. Change the
security protocol for your device to something other than WEP and TKIP or change the setting to something other than
"IEEE802.11n only."
•
For offi ce use, consult your network administrator.
Take added care when connecting to a network that is not protected with security measures, as there is a risk of disclosing
•
data such as your personal information to a third party.
•
This printer cannot be used over wireless and wired connections at the same time.
•
An "Ad-hoc connection," which establishes a direct connection to the computer over a wireless connection without an
access point, is not supported. Be sure to prepare an access point.
b Printer Setup
1. Press the MENU button (A) on the printer.