Cognex DataMan 8700 빠른 참조 매뉴얼 - 페이지 2

{카테고리_이름} Cognex DataMan 8700에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cognex DataMan 8700 16 페이지.

Precautions

To reduce the risk of injury or equipment damage, observe the following precautions

when you install the Cognex product:

This product is intended for industrial use in automated manufacturing or

similar applications.

The safety of any system incorporating this product is the responsibility of

the assembler of the system.

This product does not contain user-serviceable parts. Do not make

electrical or mechanical modifications to product components.

Unauthorized modifications can void your warranty.

Route cables and wires away from high-current wiring or high-voltage

power sources to reduce the risk of damage or malfunction from the

following causes: over-voltage, line noise, electrostatic discharge (ESD),

power surges, or other irregularities in the power supply.

Changes or modifications not expressly approved by the party responsible

for regulatory compliance could void the user's authority to operate the

equipment.

Ensure that the cable bend radius begins at least six inches from the

connector. Cable shielding can be degraded or cables can be damaged or

wear out faster if a service loop or bend radius is tighter than 10X the cable

diameter.

This device should be used in accordance with the instructions in this

manual.

All specifications are for reference purposes only and can change without

notice.