Astria Rhapsody42TEN 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Astria Rhapsody42TEN에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Astria Rhapsody42TEN 10 페이지. 42- and 54-inch linear direct vent gas fireplaces

페이지 인쇄

INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES

Gather and reseal all wiring

1. Gather all wiring and pilot connections together at the end

of the slot, and reseal with high-temperature sealant, such

as Mill-Pac

(not provided) (Figure 8).

2. Reposition the right burner bracket and secure with the

three (3) previously removed screws; tighten the fourth

screw (Figure 6).

3. Replace the control compartment access door and gasket,

and secure with the twelve (12) previously removed screws

(Figure 6).

4. Carefully slide the burner assembly venturi onto the orifice.

While placing the burner assembly onto the brackets,

reinstall the air shutter adjustment lever (Figure 5).

Secure the burner assembly with the two (2) previously

removed screws.

Install rear floor section (from required floor kit)

1. Place lower back edge of rear floor section on rear ledge of

fireplace, behind the tabs (Figure 17).

2. Align outermost front hole on either side of rear floor

section with hole in center lower tab in each side panel.

Pull rear floor section forward until it butts against the

burner, and secure using two (2) #10-16 x 3/8 hex-head

sheet metal screws provided with the floor kit (one screw

per side).

Side Panel

(Center Lower Tab)

Figure 17: Installing the rear floor section

Rear

Floor

Section

Tab

Rear

Ledge

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Install front floor section (from required floor kit)

1. Engage the lower front lip of the front floor section under

the locking clips attached to the fireplace front ledge, and

then slide it back (Figure 18).

2. Align the notches in the back edge of the front floor section

over the holes in the rear floor section. Push the front floor

section backward until it butts against the burner, and

secure it using two (2) #10-16 x 3/8 hex-head sheet metal

screws provided with the floor kit (one screw per side).

Front

Floor

Section

Front

Ledge

Lip

Locking Clip

Figure 18: Installing the front floor section

Install media (from optional media kit)

WARNING

• Handle media only when cool. Turn OFF all electricity to

the appliance before installing media. Media gets very

HOT during fireplace use and will remain hot up to ONE

HOUR after the gas supply is turned off.

• Any attempt to use media not specified for your fireplace

configuration will result in incomplete combustion, sooting,

and poor flame quality, and will void the warranty.

• Do NOT mound up media, especially on the burner.

• If using multiple colors of media, NEVER use more than

five (5) pounds total (approximately) at one time.

1. If installing a floor kit that requires media, place an even

layer of media in the recessed area around the burner (see

bold outlined area in Figure 19; also refer to Figure 1).

Figure 19: Placement of media

Notch

Rear

Floor

Section