Akw M17 DigiPump 설치 및 사용자 관리 지침 - 페이지 4

{카테고리_이름} Akw M17 DigiPump에 대한 설치 및 사용자 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Akw M17 DigiPump 20 페이지. Digipump

Important Safety & Electrical Information

THIS CLASS II APPLIANCE DOES NOT REQUIRE AN EARTH

CAUTION: 230V AC

Lethal Voltage present on the AC supply

Ensure mains power supply is switched OFF before starting wiring

DO NOT take risks with plumbing or electrical installation. This product

must be installed and serviced by a competent person in accordance with

the current edition of the Wiring Regulations (BS7671), local by-laws and

the current building regulations.

This product must be installed, used and maintained in good working

order in accordance with these instructions and recommendations.

If the supply cord is damaged, it MUST be replaced in order to avoid

hazard.

The 230V AC power supply to this unit must be provided via a two-pole isolator switch and a

dedicated circuit with a 30mA RCD device installed in accordance with the latest revision of

the Wiring Regulations BS7671. It must be wired into a fused, unswitched, fixed wiring

connector fitted with a 5 amp fuse.

The IP45 rating of the AKW pump product refers to the inner casing containing the electrical

control gear. The pump motor which operates at SELV is located within the outer cover.

AKW M17 DigiPump high performance shower waste water pump.

Pump Specification

SUPPLY: 230V AC 50Hz 100W

IP45

DUTY CYCLE: 50% max 30 mins on.

Quiet in operation.

For use with electric & mixer showers.

Pump and controller enclosed in one unit.

Max flow rate: 17 Litres Per Minute (LPM).

Non-handed

selectable inlet/outlet direction.

Note: Increased Head/Lift conditions will

affect the pump's performance.

Pump Capacity:

17 LPM MAX under head/lift

conditions.

Derate accordingly for installed

conditions.

Max Head: 1.0m (39in).

Max Lift: 0.5m (20in).

MAX COMBINED HEAD + LIFT:

1.5m (59in).