Dor-O-Matic 96000 Series 설치 지침 매뉴얼 - 페이지 2
{카테고리_이름} Dor-O-Matic 96000 Series에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dor-O-Matic 96000 Series 7 페이지. Slide control
페이지 인쇄1.
Preparation: Refer to Series 96000 Slide Installation Manual (DOM #96000-984) for header preparation instructions.
NOTE: Always disconnect
main power to operator prior to
servicing or cleaning.
2.
Final Wiring Connections:
The Series 96000 header comes from the factory "pre-wired" to minimize installation time at the job site. Connect main power to the terminal block
at the end of the header (Figure 1). Connect accessories to the terminal block on the safety beam bracket or control box as needed (Figure 2).
Refer to the instruction manual of the accessory for complete wiring details.
A.
Use a 115 volt, 60Hz, fused, 15 amp, 3-wire power supply.
B.
Externally route the main power to the side of the header with the terminal block.
Do not run the main power in the wire channel the length of the header.
C.
When wiring the header, place the main power in one wire channel and the accessory wiring in the other.
D.
Secure all conductors and connections against physical damage.
E.
Route all wiring away from moving parts, sharp edges and heat sources. Manually and slowly push doors open and closed and observe that
parts do not interfere with the wiring.
F.
Use copper conductors only.
84657-084 REV. B
INSTALLATION
FIGURE 1: POWER WIRING DIAGRAM
July 2003
2 of 7
Page