Dor-O-Matic 96000 Series Installation Instructions Manual - Page 2

Browse online or download pdf Installation Instructions Manual for Controller Dor-O-Matic 96000 Series. Dor-O-Matic 96000 Series 7 pages. Slide control

Print Page
1.
Preparation: Refer to Series 96000 Slide Installation Manual (DOM #96000-984) for header preparation instructions.
NOTE: Always disconnect
main power to operator prior to
servicing or cleaning.
2.
Final Wiring Connections:
The Series 96000 header comes from the factory "pre-wired" to minimize installation time at the job site. Connect main power to the terminal block
at the end of the header (Figure 1). Connect accessories to the terminal block on the safety beam bracket or control box as needed (Figure 2).
Refer to the instruction manual of the accessory for complete wiring details.
A.
Use a 115 volt, 60Hz, fused, 15 amp, 3-wire power supply.
B.
Externally route the main power to the side of the header with the terminal block.
Do not run the main power in the wire channel the length of the header.
C.
When wiring the header, place the main power in one wire channel and the accessory wiring in the other.
D.
Secure all conductors and connections against physical damage.
E.
Route all wiring away from moving parts, sharp edges and heat sources. Manually and slowly push doors open and closed and observe that
parts do not interfere with the wiring.
F.
Use copper conductors only.
84657-084 REV. B

INSTALLATION

FIGURE 1: POWER WIRING DIAGRAM
July 2003
2 of 7
Page