Canon DR 7550C - imageFORMULA - Document Scanner 사용자 설명서 - 페이지 24

{카테고리_이름} Canon DR 7550C - imageFORMULA - Document Scanner에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon DR 7550C - imageFORMULA - Document Scanner 31 페이지. Scanner
Canon DR 7550C - imageFORMULA - Document Scanner에 대해서도 마찬가지입니다: 브로셔 및 사양 (26 페이지), 간편한 시작 매뉴얼 (2 페이지), 보충 설명서 (7 페이지), 브로셔 및 사양 (8 페이지), 브로셔 및 사양 (4 페이지), 브로셔 및 사양 (33 페이지), 포켓 매뉴얼 (32 페이지), 포켓 매뉴얼 (30 페이지), 브로셔 및 사양 (4 페이지), 브로셔 및 사양 (4 페이지), 유지 관리 매뉴얼 (20 페이지)

Other Methods for Scanning

This section describes the various scanning options.

Changing the Feeding Option for

Scanning

Changing the feeding option setting in the scanner settings dialog box

can be helpful when scanning multipage documents.

The following three feeding options are available:

● [Standard Feeding]

This is the standard feeding method. The scanning operation ends

when the documents placed in either scanner finish scanning.

● [Panel-Feeding]

When the documents placed in either scanner finish scanning, the

scanner enters a standby state and waits for additional documents

to be placed. When you place additional documents and press the

Start button, scanning continues.

● [Automatic Feeding]

When additional documents are placed after a document finishes

feeding, the scanner automatically detects these documents and

continues scanning.

This feeding option only applies to documents placed in the feeder

of the connected Canon DR-series scanner. Documents placed on

the flatbed are not detected automatically.

Configuring the Feeding Option

This section describes how to set [Feeding Option] to [Panel-

Feeding].

Open the scanner settings dialog box from your

application.

When using CapturePerfect, for example, select [Scanner Setting]

from the [Scan] menu. For details on how to open the settings

dialog box from other applications, refer to the operation manual

of the application.

Configure the [Main Scanner/Flatbed] setting.

If the document is placed in the feeder of the connected Canon

DR-series scanner, select [Main Scanner]. If you plan to switch

between using the feeder and flatbed for scanning, select [Auto].