Doran Scales DS100 운영자 매뉴얼 - 페이지 6

{카테고리_이름} Doran Scales DS100에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Doran Scales DS100 15 페이지. Scale indicator

Section 3. Power and RS-232

The DS100 is powered from a wall mounted transformer. The transformer has a

power cord which plugs into the power jack located on the back of the scale. A

strain relief is provided to the left of the power jack. The power cord can be

looped around the strain relief to prevent accidental unplugging.

The DS100 has a standard RS-232 output. To use this feature, the optional RS-

232 cable (P/N DSOPT001 or DSOPT002) is required. To access the RS-232

terminals at the rear of the scale, remove the rear panel from the indicator as

shown in Figure 2.

Insert the cable conductors by placing a small flat blade screw driver into the

terminal slot and then push the handle of the screw driver upwards towards the

top of the indicator. This forces the terminal below to open. Insert the conductor

into the terminal and remove the screwdriver.

Fig. 2 DS100 Rear Panel