Canon L1 설치 절차 매뉴얼 - 페이지 26

{카테고리_이름} Canon L1에 대한 설치 절차 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon L1 48 페이지.
Canon L1에 대해서도 마찬가지입니다: 사용 설명서 (37 페이지)

Detach the cable cover [I], and remove the six screws

[2]; then, detach the rear cover [3].

6) Remove the screw [I], and detach the upper rear

(small) cover [2] of the finisher.

7) Cut off the face cover [3] using nippers.

8) Securely fit the connector cable of the puncher unit

to the two connectors on the PCB of the finisher.

Check to be sure that the connector is in firm con-

tact. If the puncher unit malfunctions after installa-

tion, disconnect and then connect the connector and

run a check.

<Finisher-AE 1 >

Connect it to the connectors 5705 [I] and J706 [2] of

the finisher controller PCB.