Astro Tool EUSP175 작동 지침
{카테고리_이름} Astro Tool EUSP175에 대한 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Astro Tool EUSP175 4 페이지. Portable hex die crimp
페이지 인쇄
CONNECTOR ASSEMBLY TOOLING
Operation Instructions for Portable Hex Die Crimp
The Astro Tool Corp. Portable Pneumatic Hex Die Crimper has all the features of the EUS175 "C"
frame hand crimp tool. It accepts all standard Huber/Suhner or equivalent style die sets.
The EUSP175 requires a 80-120 P.S.I. regulated, filtered and lubricated air supply. Astro offers the
11413 air regulator for this purpose.
1. Observe all caution labels on the tool before assembling dies or connecting the air supply to the tool.
2. Select the appropriate die set for the connector or contact to be crimped.
3. Raise the safety shield by depressing the safety shield lever on the side of the crimp tool.
4. Insert the stationary die in the front of the tool, slide die along slot in the tool and into die nest until
die stops and tighten 6-32 set screw with wrench provided. See figure #1.
Actuating Button
Safety Shield
Lever
5. With the safety shield raised, insert the movable die into the drive shaft die nest located in the back
of the frame. Slide die along slot and into drive shaft die nest until die stops and tighten 6-32 set screw
with wrench provided. Release the safety shield after die installation.
6. Connect a regulated, filtered and lubricated air supply to the tool.
.
ASTRO TOOL CORP.
Tool No. EUSP175
BASIC DESCRIPTION
TOOL REQUIREMENTS
BASIC OPERATION
DIE INSTALLATION
Figure # 1
CRIMPING OPERATION
1
6-32 Set Screw
Stationary Die
5-22-15 TIUS75-99-1