Astro Tool EUSP175 작동 지침 - 페이지 2

{카테고리_이름} Astro Tool EUSP175에 대한 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Astro Tool EUSP175 4 페이지. Portable hex die crimp

7. Pre-assemble the connector or contact to the prepared wire or cable following the manufacturer's

specifications.

8. Raise the safety shield by depressing the safety lever.

9. Insert and position the connector in the stationary die.

10. Release the safety shield lever. The dies will hold the connector in place.

11. Depress the actuating button on top of the tool. The tool will complete one cycle.

12. Raise the safety shield and remove the crimped assembly.

DIE REMOVAL

13. Disconnect the air supply from the tool.

14. To remove the stationary and movable die set, use wrench provided. Loosen 6-32 set screws and

remove dies from tool.

EMERGENCY RELEASE

If the crimp tool should jam in the crimp position; release the tool by depressing the Emergency

Release Lever. This releases air pressure from the air cylinder allowing the movable die to retract. See

figure # 2.

Figure # 2

INSTRUCTIONS FOR 621201 AND 621202 BENCH MOUNT

5-22-15 TIUS75-99-1