Astro Tool EUSP175 Çalıştırma Talimatları - Sayfa 2
Elektrikli Alet Astro Tool EUSP175 için çevrimiçi göz atın veya pdf Çalıştırma Talimatları indirin. Astro Tool EUSP175 4 sayfaları. Portable hex die crimp
Sayfayı Yazdır
7. Pre-assemble the connector or contact to the prepared wire or cable following the manufacturer's
specifications.
8. Raise the safety shield by depressing the safety lever.
9. Insert and position the connector in the stationary die.
10. Release the safety shield lever. The dies will hold the connector in place.
11. Depress the actuating button on top of the tool. The tool will complete one cycle.
12. Raise the safety shield and remove the crimped assembly.
DIE REMOVAL
13. Disconnect the air supply from the tool.
14. To remove the stationary and movable die set, use wrench provided. Loosen 6-32 set screws and
remove dies from tool.
EMERGENCY RELEASE
If the crimp tool should jam in the crimp position; release the tool by depressing the Emergency
Release Lever. This releases air pressure from the air cylinder allowing the movable die to retract. See
figure # 2.
Figure # 2
INSTRUCTIONS FOR 621201 AND 621202 BENCH MOUNT
2
5-22-15 TIUS75-99-1