ASTRO-MED Dash 10 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} ASTRO-MED Dash 10에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASTRO-MED Dash 10 14 페이지.

CHANNEL MASTER

The Dash 10 is equipped with thirty 128 character channel annotation buffers, one 128 character on demand annotation

buffer and one system log buffer. The thirty 128 character annotation buffers and the on demand buff er can be moved to any

of the 95 positions across the chart.

CHANGING BUFFERS AND

LOCATION

ENTERING TEXT

Channel master is used when you have a channel set up to specific parameters and

would like to have all of the recorders channels set at these parameters. Instead of

changing the parameters on each separate channel:

• Press the soft key below "CHANNEL MASTER".

The CHANNEL MASTER menu will appear.

• Turn the encoder wheel to select the channel that you want all of your

channels parameters to be set to.

• Press the soft key below "BEGIN".

Congratulations! All your channels will now have the same parameters as the

selected channel.

• Press the soft key below "EXIT".

• Press the soft key below "more" to return to the first Z/G menu.

• Turn the encoder wheel to verify that all the channel parameters are the same.

For information on how to use User Scaling see the Operations Manual.

5. ENTERING TEXT ANNOTATION

Text annotation is easy to enter. Press the front panel [EDIT] key. The EDIT

menu will appear. The word Syslog under "BUFFER" should be blinking. This

indicates the attribute that you are working on (in this case it is the "SYSLOG

BUFFER"). Turn the encoder wheel to change the buffers. Notice that there is one

Syslog buffer, 30 channel buffers labeled 1 - 30 and one Demand buffer.

• Turn the encoder wheel un til 3 appears under "BUFFER".

• Press the soft key above "STATUS". This toggles the buffer status between ON

and OFF. If the "STATUS" is OFF the buffer WILL NOT print.

• Press the soft key above "LOCATION". The number under "LOCATION" will

blink. Turning the encoder wheel will change the location of BUFFER 3.

Let's try to enter some custom text.

• Press the [RUN/HALT] key to stop the chart.

You should still be in the EDIT menu, if not press [EDIT] and make sure

that you are in BUFFER 3.

• Press the soft key below "EDIT".

• The text "Channel #3" will appear in BUFFER 3.

• If you want to type in upper case letters press the soft key below "CASE" until

*CAPS* appears on the display.

• Using the alphanumeric keypad press the key until the blinking cursor is 2

spaces past the text "Channel #3".

• Type the letters "TEST".

• Press the soft key below "ACCEPT".

• Press the [RUN/HALT] key.

Notice that BUFFER 3 now reads "Channel #3 TEST" on the chart.

Congratulations! You now know how to edit/add text as well as change the location.