ASTRO-MED Dash 10 Краткое руководство по эксплуатации - Страница 9

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Измерительные приборы ASTRO-MED Dash 10. ASTRO-MED Dash 10 14 страниц.

ASTRO-MED Dash 10 Краткое руководство по эксплуатации
CHANNEL MASTER
The Dash 10 is equipped with thirty 128 character channel annotation buffers, one 128 character on demand annotation
buffer and one system log buffer. The thirty 128 character annotation buffers and the on demand buff er can be moved to any
of the 95 positions across the chart.
CHANGING BUFFERS AND
LOCATION

ENTERING TEXT

Channel master is used when you have a channel set up to specific parameters and
would like to have all of the recorders channels set at these parameters. Instead of
changing the parameters on each separate channel:
• Press the soft key below "CHANNEL MASTER".
The CHANNEL MASTER menu will appear.
• Turn the encoder wheel to select the channel that you want all of your
channels parameters to be set to.
• Press the soft key below "BEGIN".
Congratulations! All your channels will now have the same parameters as the
selected channel.
• Press the soft key below "EXIT".
• Press the soft key below "more" to return to the first Z/G menu.
• Turn the encoder wheel to verify that all the channel parameters are the same.
For information on how to use User Scaling see the Operations Manual.
5. ENTERING TEXT ANNOTATION
Text annotation is easy to enter. Press the front panel [EDIT] key. The EDIT
menu will appear. The word Syslog under "BUFFER" should be blinking. This
indicates the attribute that you are working on (in this case it is the "SYSLOG
BUFFER"). Turn the encoder wheel to change the buffers. Notice that there is one
Syslog buffer, 30 channel buffers labeled 1 - 30 and one Demand buffer.
• Turn the encoder wheel un til 3 appears under "BUFFER".
• Press the soft key above "STATUS". This toggles the buffer status between ON
and OFF. If the "STATUS" is OFF the buffer WILL NOT print.
• Press the soft key above "LOCATION". The number under "LOCATION" will
blink. Turning the encoder wheel will change the location of BUFFER 3.
Let's try to enter some custom text.
• Press the [RUN/HALT] key to stop the chart.
You should still be in the EDIT menu, if not press [EDIT] and make sure
that you are in BUFFER 3.
• Press the soft key below "EDIT".
• The text "Channel #3" will appear in BUFFER 3.
• If you want to type in upper case letters press the soft key below "CASE" until
*CAPS* appears on the display.
• Using the alphanumeric keypad press the key until the blinking cursor is 2
spaces past the text "Channel #3".
• Type the letters "TEST".
• Press the soft key below "ACCEPT".
• Press the [RUN/HALT] key.
Notice that BUFFER 3 now reads "Channel #3 TEST" on the chart.
Congratulations! You now know how to edit/add text as well as change the location.
8