ASTRO-MED DASH II 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} ASTRO-MED DASH II에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASTRO-MED DASH II 8 페이지.

페이지 인쇄

SECOND SCREEN OF THE MAIN MENU

Trig

Ctrl

•

Press the softkey below "Disk I/O." The Disk I/O menu will appear.

DISK I/O MENU

File

Mgmt

•

Place a DOS formatted, 3.5" floppy disk into the disk drive on the front panel of the Dash II.

•

Press the softkey below "Syst File." You will have the option to save, load, execute and go back to the

previous menu.

•

Press the button below "Save" and rotate the encoder wheel until the flashing file name reads:

"DASH2_xx.NEW" where xx designates the file number and can range from 01 to 99.

•

Press the softkey below "EXEC" to save the setup configuration file. Notice that the file extension

changes from .NEW to .CFG.

To load a system configuration file from a floppy disk:

•

Place a disk containing the desired setup file into the disk drive on the front panel of the Dash II.

•

From the Disk I/O menu, press the softkey below "Syst File."

•

Press the softkey below "Load" and rotate the encoder wheel until the desired setup file is flashing on

the screen. The file name should read "DASH2_xx.CFG" where xx designates the file number.

•

Press the softkey below "EXEC" to load the file into the recorder.

5. SETTING UP ZERO AND GAIN

The [CH1] and [CH2] keys (Channel 1 and Channel 2) are used to set a variety of parameters, including:

turning each channel on/off, selecting a voltage sensitivity for a channel, selecting a location for the input

zero position, suppressing a DC component of the waveform input, choosing between RMS and peak to

peak recording modes, grounding the input signal, selecting between standard voltage inputs and bridge

inputs, selecting filters and calibrating each channel.

•

Press the [CH1] key. The Channel 1 menu will appear. Note: The channel 2 menus and operations are

identical to those of Channel 1.

CHANNEL 1 MENU

1 - DC

Sens

The first line shows the channel status. In the above example, channel 1 is in DC mode at a sensitivity of

5.0 volts full scale.

SENSITIVITY In the new generation DASH II recorder, voltage is expressed in reference to full scale.

Since signal size is independent of grid size, a finer or coarser view of the signal data can be obtained by

adjusting channel sensitivity.

Capt

Plbk

Cnfg

Syst

Recd

File

5.0 V fs

Disk

I/O

Pos