AstroLink 4 Pi 매뉴얼 - 페이지 5

{카테고리_이름} AstroLink 4 Pi에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AstroLink 4 Pi 17 페이지.

AstroLink 4 Pi manual - astrojolo.com

Hardware setup

Raspberry Pi

installation

Figure 2 - enclosure screws

Installing the Raspberry Pi

module requires opening the AstroLink 4 Pi enclosure. You need to

unscrew four out of eight screws at the device's sides. Please remove only bottom screws. Then

remove enclosure top. After that, you need to unplug the cooling fan.

Figure 3 - Raspberry Pi module fixing screws

Then remove four screws that fix the Raspberry Pi

module and place the module in the device.

Watch the proper position of the GPIO socket. Put the Raspberry Pi

sockets into the holes in the

front device panel and push the pins down to the GPIO socket. Then fix the Raspberry Pi

module

with four screws, connect the fan (refer to Figure 4 for the fan polarity), and mount the top part of

the enclosure. The last step is to put back four screws at the device's sides.

Raspberry Pi is a trademark of Raspberry Pi Trading

Rev. 1.0