COLDBUSTER FLOORHEATING Timber 설치 매뉴얼 - 페이지 5

{카테고리_이름} COLDBUSTER FLOORHEATING Timber에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. COLDBUSTER FLOORHEATING Timber 16 페이지.

Electrical Information

The Coldbuster heater element has been classified as an electrical appliance. You must engage a

licensed electrician for the heater installation if this is required by your state regulations.

However, all electrical connections, including setting up the conduits (more detail below) and the

connection of the thermostat must be undertaken by a licensed electrician in accordance with

current electrical codes of practice, AS/NZS3000: 2007 and state codes.

1. The heater element must be connected to

a circuit with RCD protection.

2. Consult with your electrician to ensure any

existing cabling and RCD already installed

are working and capable of handling the

additional load.

• Power supply must be RCD protected

• Standard flush box or C-bracket mounted

horizontally or vertically, height between

1000mm - 1500mm above the floor

• 20mm conduit for the heater leads

o Number of leads per conduit depends

on size of conduit

o Maximum 2 heaters per conduit

• 20mm conduit for floor sensor extended

into the room

(optional: most thermostats have a built-in

sensor and can be set up for air sensor)

• Thermostat mounted between 300 - 600mm from the

floor

• Power point must be RCD protected

• Option A: For cavity walls, fit heater lead and floor

temperature sensor inside the cavity

• Option B: For brick walls, fit heater lead and floor

temperature sensor inside PVC trunking and notch

out the thermostat baseplate for cable access

Floor Sensor Preparation

• Install the floor sensor as shown in the electrical connection drawing, particularly if another

form of heating such as air conditioning or a fireplace will also be used in the area

• After the heating is laid, the floor sensor should be secured at an even distance between 2 of

the heater runs

(typically provided with your thermostat)