COLDBUSTER FLOORHEATING Timber 설치 매뉴얼 - 페이지 6

{카테고리_이름} COLDBUSTER FLOORHEATING Timber에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. COLDBUSTER FLOORHEATING Timber 16 페이지.

Floor Preparation

This guide intends to serve only as an outline for the most common floor preparation required.

Please contact us for any additional advice.

• The concrete must be completely cured (this can take up to 8 weeks)

• The floor surface must be smooth, unpainted and free of dust, oil, grease, tar and glue residues

• Clean and sweep or vacuum floor surface

• The floor should be rigid and free from movement

• Install a fibre cement underlay or insulation board over the timber structural floor before tiling

• The floor surface must be smooth, unpainted and free of dust, oil, grease, tar and glue residues

• Clean and sweep or vacuum floor surface

• After the heating is placed, Coldbuster recommends laying a 10-15mm sand cement or liquid

leveller over the heater so there is a medium between the heating element and the flooring

Prepping Subfloor Surface with a Bonding Liquid

(If heater(s) don't stick due to dusty floor surface)

1. Apply a coat of bonding liquid mixed 1:4 with water using a paint roller & tray (avoid ponding),

2. Allow bonding liquid to dry completely before installing heater(s)