COLDBUSTER FLOORHEATING Timber 설치 매뉴얼 - 페이지 8

{카테고리_이름} COLDBUSTER FLOORHEATING Timber에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. COLDBUSTER FLOORHEATING Timber 16 페이지.

Pre-Heater Installation

Step 1: Create Cavity Below Thermostat

• The purpose of the cavity is to allow the connection joint (the rubbery

insulation covered junction between the element and cold tail) to be

recessed into the floor

• Using a chisel and hammer or angle grinder, chip away some of the sub

floor with a chisel to form a 10mm deep cavity

• The width of the cavity will depend on the number of heaters to be

connected to the thermostat

Step 2: Place Cold Tail

• Connect (e.g. using tape) the cold tail to the draw wire and pull it up through the pre-installed conduit

or wall cavity to the thermostat position

• Secure (using either hot glue or tape) the connector joint(s) into the cavity created below the

thermostat position

Step 3: Connect Monitor

• The purpose of the monitor is to confirm that the heater is working and not been compromised.

• The monitor should remain connected until the floor has been installed and your electrician connects

the thermostat.

• Test the monitor before connecting to heater: Switching the monitor on with no heater connection

should sound the alarm and turn on the red light. If these things don't occur, check that the battery is

connected properly or replace the battery.

• Ensure the heaters to be monitored are not connected to a power source

• Connect the various wires to the alligator clips and pull the rubber boots over the metal clips:

o Green alligator clip – green wire

o Red alligator clip – brown wire

o Black alligator clip – blue wire

o Recommendation: Each clip can be taped up with insulation tape to prevent the clips from

touching and setting off the alarm

• Once connected, there should be a white light which indicates that the monitor is checking the heater

for damage.

• Hang or place the monitor where it can be seen and heard during the installation

• Should the white light go out, batteries will need to be replaced

• The alarm sounding and a red light indicates that, either:

o A lead wire has come loose from the terminals;

o The red or black alligator clip is touching the green alligator clip; or

o Damage has occurred to the heater.

• It is important to stop work and identify the cause of the alarm sounding immediately.

• In the event of damage to the heater, call Coldbuster on 1800 85 75 65 for assistance.