Coldelite UF-203G 매뉴얼 - 페이지 12

{카테고리_이름} Coldelite UF-203G에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coldelite UF-203G 17 페이지. Gravity soft serve freezers

3) Slide the sleeve onto the tube. Please note that the slots in

7) Install the two (2) mix level floats by simply sliding one each

the sleeve should be at the top of the tube when installed.

onto the stainless steel shaft in the mix tank.

4) Slide the splash guard into the tube.

5) Lubricate the two O-rings with sanitary lubricant.

The machine is now completely assembled and ready to be

sanitized.

PART Ill

SANITIZING THE FREEZER

Prior to starting the machine with your soft serve product, the

machine must be sanitized. The frequency of cleanina

and

. -

sanitizing cycles must comply with local health regulations. If

uncertain about local regulations, contact your local Board of

Health.

Sanitizing the machine is most important. This procedure will

retard the growth of bacteria and insure excellent test results

on your product when examined by local Health and/or

Agriculture Departments.

To begin, you will need a clean pail, sanitizer (sample packets

included in the start-up kit), spatula (included in start-up kit),

and brush (plastic bristle).

6) Insert the assembled tubes into the hole at the bottom of

the mix tank. Press the tube down until it seats and the

flange at the base of the tube rests against the bottom of

the mix tank.