Asus A7N8X-LA (Focus) 사용자 설명서 - 페이지 13

{카테고리_이름} Asus A7N8X-LA (Focus)에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Asus A7N8X-LA (Focus) 18 페이지. Microatx motherboard
Asus A7N8X-LA (Focus)에 대해서도 마찬가지입니다: 사용자 설명서 (18 페이지), 사용자 설명서 (19 페이지)

페이지 인쇄

3. IDE connectors (40-1 pin IDE1, IDE2)

This connector supports the provided UltraDMA/100/66/33 IDE hard disk ribbon

cable. Connect the cable's blue connector to the primary (recommended) or

secondary IDE connector, then connect the gray connector to the

UltraDMA/100/66/33 slave device (hard disk drive) and the black connector to

the UltraDMA/100/66/33 master device. It is recommended that you connect

non-UltraDMA/100/66/33 devices to the secondary IDE connector. If you install

two hard disks, you must configure the second drive as a slave device by setting

its jumper accordingly. Refer to the hard disk documentation for the jumper

settings. BIOS supports specific device bootup. If you have more than two

UltraDMA/100/66/33 devices, purchase another UltraDMA/100/66/33 cable. You

may configure two hard disks to be both master devices with two ribbon cables –

one for the primary IDE connector and another for the secondary IDE connector.

1. Pin 20 on each IDE connector is removed to match the covered hole on the

UltraDMA cable connector. This prevents incorrect orientation when you

connect the cables.

2. The hole near the blue connector on the UltraDMA/100/66 cable is intentional.

A7N8X-LA/Explorer2

IDE Connectors

ASUS A7N8X-LA (Explorer 2) Motherboard

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PIN 1