bolid IPR 513-3M 컨벤셔널 매뉴얼 - 페이지 9

{카테고리_이름} bolid IPR 513-3M에 대한 컨벤셔널 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. bolid IPR 513-3M 15 페이지.
bolid IPR 513-3M에 대해서도 마찬가지입니다: 사용 설명서 (2 페이지)

2.2.3 Mounting

The MCP is to be mounted to a flat vertical surface in

line with Buildings Codes and Regulations. The MCP rear

panel (base) is attached to the wall with two screws. The

front part of the housing is installed on the mounted base

after connecting wires to the terminal block. The wires that

pass under the rear panel should not be clamped by the MCP

housing.

Figure 2.2.3.1 shows the view of the MCP (without

the protective flip cover).

1: Hole to insert the key to reset the activated MCP;

2: Holes to insert the key to open the MCP housing;

3: Special key to reset the activated MCP / to open its housing;

4: Place to apply a seal.

Figure 2.2.2.2 Mounting Dimensions for the MCP

Figure 2.2.3.1. Parts of the MCP