bolid S2000-SP1 ORION ISS 설치 매뉴얼 - 페이지 2

{카테고리_이름} bolid S2000-SP1 ORION ISS에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. bolid S2000-SP1 ORION ISS 8 페이지. Executive relay module
bolid S2000-SP1 ORION ISS에 대해서도 마찬가지입니다: 사용 설명서 (10 페이지)

페이지 인쇄

2.3 If the module is to be mounted within unprotected premises, it is recommended to mount it

at a height of minimum 2.2 m above the floor.

Figure 1. Overall and Mounting Dimensions of the Module

3 MOUNTING THE MODULE

3.1 Mounting on a Wall

Unscrew the

3.1.1 Please ensure that the wall the

screw fixing the

module is to be mounted to is solid, flat,

cover

clean, and dry.

3.1.2 Attach the module to the wall in

accordance with the Variant 1 or Variant 2

Push the top end of

below.

the front cover down

by your thumbs

3.1.3 Variant 1. Apply the Mounting

Pattern (page 7) to the wall. Drill three

holes (A, B and C or D).

Slide the

3.1.4 Insert wall plugs to the holes and

cover

forward

screw provided woodscrews to the two

upper holes so that a distance between a

screw head and the wall is about 7 mm.

3.1.5 Remove the module cover as

shown in Figure 2.

3.1.6 Hang the module on the two

screws. Screw the third screw into the

bottom mounting hole and fasten the

module to the wall.

3.1.7 Variant 2. Apply the Mounting

Pattern (page 7) to the wall. Drill three

Figure 2. Opening the front cover

holes (A, B and C or D)

3.1.8 Insert wall plugs to the holes.

www.bolid.com

S2000-SP1 ver.1.56 INSTALLATION MANUAL rev.0