Canon LV-5200 소유자 매뉴얼 - 페이지 31
{카테고리_이름} Canon LV-5200에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon LV-5200 48 페이지. Canon lv-5200: user guide
Canon LV-5200에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지)
페이지 인쇄
VIDEO INPUT
Choose Video by pressing the INPUT button on the Top Control or on
the Remote Control Unit.
If the projector cannot reproduce a proper video source, select correct
input source through the "MENU OPERATION" (see below).
RGB Scart Input
To select RGB Scart 21-Pin video input through RGB IN 1 / OUT
terminal, see the "COMPUTER INPUT (RGB Scart 21-Pin Video
Input)" on page 22.
1
Press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT LEFT/RIGHT button to move the red
frame pointer to the INPUT Menu icon.
2
Press the POINT DOWN button to move the red arrow pointer to
Video and then press the SET button. The Source Select Menu
will appear.
3
Move the pointer to the source that you want to select and then
press the SET button.
When selecting Auto, the projector automatically detects
Auto
the incoming video signal, and adjusts itself to optimize
its performance. The projector selects the connection in
the following order:
1st Y-Pb/Cb-Pr/Cr
2nd S-VIDEO
3rd VIDEO
Y-Pb/Cb-Pr/Cr has priority over S-VIDEO. S-VIDEO has
priority over VIDEO.
When the video input signal is connected to VIDEO/Y
Video
jack, select Video.
When the video input signal is connected to S-VIDEO
S-Video
jack, select S-Video.
When the video input signal is connected to
Y,Pb/Cb,Pr/Cr
VIDEO/Y-Pb/Cb-Pr/Cr jacks, select Y, Pb/Cb, Pr/Cr.
SELECTING THE INPUT SOURCE
DIRECT OPERATION
MENU OPERATION
INPUT button
✽
Computer 1
Computer 2
Video
✽
Computer 1 is not displayed when RGB IN 1/ OUT
terminal is used as MONITOR OUT.
INPUT MENU
VIDEO
Source Select Menu (VIDEO)
Move the pointer to the source and press the SET
button.
✽
Computer 1 is not displayed when RGB IN 1/ OUT
terminal is used as MONITOR OUT.
Move the pointer to
Video and press the
SET button.
31