Canon LV-7225 - LCD Multimedia Projector XGA 기능 사양 - 페이지 13
{카테고리_이름} Canon LV-7225 - LCD Multimedia Projector XGA에 대한 기능 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon LV-7225 - LCD Multimedia Projector XGA 42 페이지. Multimedia projectors
Canon LV-7225 - LCD Multimedia Projector XGA에 대해서도 마찬가지입니다: 기능 사양 (20 페이지), 사양 (6 페이지)
페이지 인쇄
Expand Serial Command Functional Specification
8.4. Image Command
8.4.1. CF_BRIGHT Command
Command
"CF"_BRIGHT_%1" [CR]
"000 – 063" ----------- Directly select the Bright setting value
%1
"UP" -------------------- Bright setting value +1
"DN" -------------------- Bright setting value -1
Set the user control Bright value.
The value set by the command will not be saved to the Projector.
Details
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable
Response
Unacceptable
8.4.2. CF_CONT Command
Command
"CF_CONT_%1" [CR]
"000 – 063" ------------ Directly select the Contrast setting value
%1
"UP" --------------------- Contrast setting value +1
"DN" --------------------- Contrast setting value -1
Set the user control Contrast value.
The value set by the command will not be saved to the Projector.
Details
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable
Response
Unacceptable
8.4.3. CF_COLOR Command
Command
"CF_COLOR_%1" [CR]
"000 – 063" ------------ Directly select the Color setting value
%1
"UP" --------------------- Color setting value +1
"DN" --------------------- Color setting value -1
Set the user control Color value.
The value set by the command will not be saved to the Projector.
Details
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable
Response
Unacceptable
8.4.4. CF_TINT Command
Command
"CF_TINT_%1" [CR]
"000 – 063" ------------ Directly select the Tint setting value
%1
"UP" --------------------- Tint setting value +1
"DN" --------------------- Tint setting value -1
Set the user control Tint value.
The value set by the command will not be saved to the Projector.
Details
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
Page 12 of 41