Canon LV-7225 - LCD Multimedia Projector XGA 기능 사양 - 페이지 14
{카테고리_이름} Canon LV-7225 - LCD Multimedia Projector XGA에 대한 기능 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon LV-7225 - LCD Multimedia Projector XGA 42 페이지. Multimedia projectors
Canon LV-7225 - LCD Multimedia Projector XGA에 대해서도 마찬가지입니다: 기능 사양 (20 페이지), 사양 (6 페이지)
페이지 인쇄
Expand Serial Command Functional Specification
8.4.5. CF_SHARP Command
Command
"CF_SHARP_%1" [CR]
"000 – 015" ------------ Directly select the Sharpness setting value
%1
"UP" --------------------- Sharpness setting value +1
"DN" --------------------- Sharpness setting value -1
Set the user control Sharpness value.
The value set by the command will not be saved to the Projector. Therefore, when
Details
AC Power Off the Projector, the value will return to the original setting. (For
Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable
Response
Unacceptable
8.4.6. CF_GAMMA Command
Command
"CF_GAMMA_%1" [CR]
"000 – 015" ------------ Directly select the Gamma setting value
%1
"UP" --------------------- Gamma setting value +1
"DN" --------------------- Gamma setting value -1
Set the user control Gamma value.
The value set by the command will not be saved to the Projector. Therefore, when
Details
AC Power Off the Projector, the value will return to the original setting. (For
Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable
Response
Unacceptable
8.4.7. CF_WBAL- Command
Command
"CF_WBAL-%1_%2" [CR]
"R" -------------------- Red
%1
"G" -------------------- Green
"B" -------------------- Blue
"000 – 063" ------- Directly select color value by White Balance %1 determination
%2
"UP" ---------------- Color value for White Balance %1 determination +1
"DN" ---------------- Color value for White Balance %1 determination -1
Set the user control value by White Balance %1 determination.
The value set by the command will not be saved to the Projector. Therefore, when
Details
AC Power Off the Projector, the value will return to the original setting. (For
Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable
Response
Unacceptable
8.4.8. CF_COLTEMP Command
Command
"CF_COLTEMP_%1" [CR]
"000" ----------- Xlow
"001" ----------- Low
%1
"002" ----------- Mid
"003" ----------- High
Set the Color Temp.
The value set by the command will not be saved to the Projector. Therefore, when
Details
AC Power Off the Projector, the value will return to the original setting. (For
Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
Page 13 of 41