Cansec H1000 설치 매뉴얼 - 페이지 19
{카테고리_이름} Cansec H1000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cansec H1000 20 페이지. Elevator control
페이지 인쇄Wiegand-Compatible Reader Wiring
The elevator reader, which is mounted in the elevator cab, can read a standard 26-bit or Cansec
37-bit Wiegand proprietary format card or the HID Corporate 1000 format card. The H1000 uses
a small 6 pin keyed connector to terminate the reader wiring.
The H1000 reader connections are labeled below the reader connectors, as shown below. The 12
VDC power is supplied to the reader through the reader connector.
The H1000 reader uses an auto-resettable fuse with a 1 amp maximum rating.
A 6-conductor overall shield wire is required for proper Wiegand reader connection. See the
reader manufacturer for the wire gauge requirement for different reader distances to the control
panel.
Connect elevator reader to port RD1 only.
Connecting Wiegand-Compatible Reader
H1000 Elevator Control
Installation Guide
This reader is mounted in the
elevator cab.
Page 19 of 20
October 2015 • Rev. 1.7