Cansec H1000 Manual de instalação - Página 19

Procurar online ou descarregar pdf Manual de instalação para Controlador Cansec H1000. Cansec H1000 20 páginas. Elevator control

Wiegand-Compatible Reader Wiring

The elevator reader, which is mounted in the elevator cab, can read a standard 26-bit or Cansec

37-bit Wiegand proprietary format card or the HID Corporate 1000 format card. The H1000 uses

a small 6 pin keyed connector to terminate the reader wiring.

The H1000 reader connections are labeled below the reader connectors, as shown below. The 12

VDC power is supplied to the reader through the reader connector.

The H1000 reader uses an auto-resettable fuse with a 1 amp maximum rating.

A 6-conductor overall shield wire is required for proper Wiegand reader connection. See the

reader manufacturer for the wire gauge requirement for different reader distances to the control

panel.

Connect elevator reader to port RD1 only.

Connecting Wiegand-Compatible Reader

H1000 Elevator Control

Installation Guide

This reader is mounted in the

elevator cab.

Page 19 of 20

October 2015 • Rev. 1.7