Cansec SmartLock UltraLite Plus 설치 매뉴얼 - 페이지 3

{카테고리_이름} Cansec SmartLock UltraLite Plus에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cansec SmartLock UltraLite Plus 16 페이지.

Introduction

SmartLock UltraLite Plus is an extremely simple, stand-alone access control system that

supports up to 2,000 users with a 1,000 record, time-stamped audit trail capacity. All

programming is done at the PC, using software which is simple, intuitive and supports

up to 255 UltraLite Plus controllers. When used with the CanProx One proximity

reader, the UltraLite Plus system becomes one of the most cost-effective stand-alone,

expandable systems on the market.

The SmartLock UltraLite Plus controller features a form "C" relay output for lock

control as well as inputs for a request-to-exit button and a door contact. If a door

contact input is connected, the controller will automatically relock the door once it re-

closes. In addition, an audible alert can be generated on the reader if the door is held

open longer than a specified time.

IMPORTANT: If no door contact is used, the door contact input must be shorted to

ground. Failure to do this will result in erratic operation.

IMPORTANT: In some jurisdictions the use of a UL-approved power supply

and connection to the fire alarm system for emergency release may be

required. Installers should contact the fire marshal office or local

authority having jurisdiction to verify the specific requirements. A building

permit may be required in some jurisdictions for the installation of maglocks.

NOTE: Tech Support will only be provided where product installation guidelines

have been followed.

SmartLock

UltraLite Plus

Installation Manual

Page 3 of 16

Oct 2013 • Rev. 1.6