Cantaloupe Radio BA32 Factory+ 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Cantaloupe Radio BA32 Factory+에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cantaloupe Radio BA32 Factory+ 8 페이지. Bluetooth retrofit kit

SOURCE SELECTION

To switch from tuner to Bluetooth or Bluetooth to aux, push and

release the volume knob. To switch from aux back to tuner,

press the 1/EJ button.

PLAY/PAUSE

To play or pause the Bluetooth track, press the 5/PROG but-

ton in Bluetooth mode. The playback state is indicated on the

display. A "1" indicates content is playing and a "2" indicates it

is paused.

PREVIOUS/NEXT TRACK

To seek to the previous or next Bluetooth track, use the corre-

sponding SEEK button while in Bluetooth mode.

REWIND/FAST-FORWARD

To rewind through Bluetooth content, press the 3/REW button.

To fast-forward, press the 4/FF button. To end either of these

actions, press the same button again, or press the 5/PROG

button. Note that depending on the currently-playing applica-

tion on the mobile device, these may have different behaviors

(continuous scrub vs. skip ahead/back) or not be supported.

VOICE ASSISTANT

Your mobile device's voice assistant can be invoked directly

from the radio by pressing the 1/EJ button in Bluetooth mode.

After a short delay, your assistant's chime will play to indicate

it is now listening for your command. Say your command and

the assistant will respond. To dismiss the assistant at any time,

press the 1/EJ button again.

When an incoming phone call is ringing, you can answer the

call by pressing the 5/PROG button. To reject an incoming call,

press the 1/EJ button. During a call, it can be ended by press-

ing the 5/PROG button.

AUTOMATIC SOURCE SWITCH FOR CALLS

To ensure an incoming call is not missed, the radio will au-

tomatically switch to Bluetooth mode if a call comes in while

another source is selected.

DOLBY

NOISE REDUCTION

Note that it is still possible to engage Dolby Noise Reduction in

Bluetooth and aux mode. However, it should NOT be enabled

as it causes decreased audio clarity. It is disabled by default,

but if a

icon is shown on the display, press the 2 button to

disable it.