Asus Z97I-PLUS 매뉴얼 - 페이지 29
{카테고리_이름} Asus Z97I-PLUS에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asus Z97I-PLUS 46 페이지.
페이지 인쇄
1.2.9
Internal connectors
1.
Intel
®
Z97 Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_1-4)
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
If you installed Serial ATA hard disk drives, you can create a RAID 0, 1, 5, and 10
chipset.
Z97I-PLUS SATA 6.0Gb/s connectors
RAID set using these connectors, set the SATA Mode Selection item in the BIOS to
RAID]. Refer to section 3.6.3 PCH Storage Configuration for details.
bundled in the motherboard support DVD.
[AHCI]. See section 3.6.3 PCH Storage Configuration for details.
2.
Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port. Connect
the S/PDIF Out module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
Z97I-PLUS Digital audio connector
The S/PDIF module is purchased separately.
ASUS Z97I-PLUS
®
Rapid Storage Technology through the onboard Intel
A
SATA6G_1
SATA6G_3
GND
GND
RSATA_TXP1
RSATA_TXP3
RSATA_TXN1
RSATA_TXN3
GND
GND
RSATA_RXN1
RSATA_RXN3
RSATA_RXP1
RSATA_RXP3
GND
GND
SATA6G_2
SATA6G_4
A
GND
GND
RSATA_TXP2
RSATA_TXP4
RSATA_TXN2
RSATA_TXN4
GND
GND
B
RSATA_RXN2
RSATA_RXN4
RSATA_RXP2
RSATA_RXP4
GND
GND
AHCI] by default. If you intend to create a Serial ATA
SPDIF_OUT
B
5.1 RAID configurations or the guide
®
Z97
1-15