DAF LF 빠른 참조 매뉴얼 - 페이지 12
{카테고리_이름} DAF LF에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAF LF 19 페이지.
페이지 인쇄Quick Reference Guide
Forced stationary regeneration
1
When Passive and Active Regeneration is not sufficient the system will prompt that a
forced stationary regeneration is required.
A forced stationary regeneration is performed at stand-still and triggered by the driver.
To prevent the engine derating power, perform regeneration of the DPF as soon as
safely possible.
Four different levels of pop-up messages are possible to warn you the DPF must be
regenerated stationary.
1. Soot level high. Regeneration required (yellow).
An alternative to overcome this is to take the motorway route which will
clear the soot via passive regeneration.
If ignored this warning will re-appear at the next and subsequent
key cycles.
2. Soot level too high. Start regeneration immediately (yellow).
Again, to overcome this is to take the motorway route.
3. Soot level full. Regeneration required now (yellow).
The engine derates power and a forced stationary regeneration is
required as soon as safely possible.
4. Soot level full. Service required (red).
The engine derates power and an authorised DAF Service dealer must
service the vehicle.
It is no longer possible to perform a forced stationary regeneration.
Safety checks
Before starting a forced stationary regeneration, make sure that following safety checks
have been met:
– The vehicle is parked outside with a minimum of 2 metres clear space around the
exhaust discharge pipe.
– The park brake is applied.
– The engine is running at idle speed.
– The vehicle is NOT left unattended.
– The coolant temperature is above 65 degrees.
9