Dot-Spot brilliance RGB 운영자 매뉴얼 - 페이지 15

{카테고리_이름} Dot-Spot brilliance RGB에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dot-Spot brilliance RGB 20 페이지. Recessed luminaire

Electrical connection

Brilliance RGB

fc funk

Tilting of the LED lamp

The brilliance recessed luminaire is available with four different dispersion angles:

10, 20, 25 and 35 degrees. In order to reduce the blinding effect and to optimize illumina-

tion, the LED lamp mount can be pivoted by up to 25 degrees in each direction and turned

by 360 degrees. Setting must be done and tested before installation (see fig. 6).

The lamps are pre-set to an angle of 0 degrees.

Slightly loosen the four fixing screws of the pressure ring underneath the spot with

a Phillips screwdriver. Do not completely unscrew the screws and do not remove the

ball from the housing.

2. Set the desired angle by turning the ball and screw tight the four screws until the

pressure ring in the screw area lies flat against the housing (a slight deformation of

the pressure ring is normal).

During this procedure, the spot must be absolutely dry and clean. In particular, no

dirt or water must enter between the housing and the ball.

3. Check the settings before installing the spot.

Electrical connection / tilting of the LED lamp

nt 12/60

230 V / 50 Hz

nt 12/30

fb funk

Fig. 5, easy RGB

freely configurable

wiring

230 V / 50 Hz