Dot-Spot brilliance RGB Instrukcja obsługi - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Oświetlenie krajobrazu Dot-Spot brilliance RGB. Dot-Spot brilliance RGB 20 stron. Recessed luminaire
Drukuj stronęElectrical connection
Brilliance RGB
fc funk
-
+
B
G
R
Tilting of the LED lamp
The brilliance recessed luminaire is available with four different dispersion angles:
10, 20, 25 and 35 degrees. In order to reduce the blinding effect and to optimize illumina-
tion, the LED lamp mount can be pivoted by up to 25 degrees in each direction and turned
by 360 degrees. Setting must be done and tested before installation (see fig. 6).
The lamps are pre-set to an angle of 0 degrees.
1.
Slightly loosen the four fixing screws of the pressure ring underneath the spot with
a Phillips screwdriver. Do not completely unscrew the screws and do not remove the
ball from the housing.
2. Set the desired angle by turning the ball and screw tight the four screws until the
pressure ring in the screw area lies flat against the housing (a slight deformation of
the pressure ring is normal).
During this procedure, the spot must be absolutely dry and clean. In particular, no
dirt or water must enter between the housing and the ball.
3. Check the settings before installing the spot.
Electrical connection / tilting of the LED lamp
nt 12/60
230 V / 50 Hz
nt 12/30
fb funk
Fig. 5, easy RGB
freely configurable
wiring
230 V / 50 Hz
15