Electra Light RGB 10W – Di-PA 사용자 설명서 - 페이지 3
{카테고리_이름} Electra Light RGB 10W – Di-PA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electra Light RGB 10W – Di-PA 4 페이지. Laser show system
페이지 인쇄Emergency Stop Box
This emergency stop box should
be connected well to the high
power laser projector. Keep the
key switch on, for the emergency
safety, just press the RED button.
It will control the laser projector, no
laser out put. Standard package
with 5 Meter DB9 connect cable.
Maintenance
☆ Please clean the lens regularly. Do not do it using the wet cloth or
other chemical. the clean times is depend on the using frequency
and surrounding condition. It is recommended that should be
cleaned every 20 days.
☆ Please clean the lighting surface and engine outlet regularly.
☆ Be sure that there is no flammable or explosive subject nearby. The
least distance is 0.5 meters. at the same time, keep more than
15cm between the wall and laser lighting;
Warning
Power off before installation or maintenance;
The danger class of this laser lighting is CLASS Ⅲ B. It's
dangerous for observing laser. The safe minimum distance is
13cm,the safe maximum time is 10 seconds;
Keep at least 0.5 meters distance between the lighting and
flammable material;
----------------- 4 -------------------
Inspection
Check for the contents in the package refer to the following
1. 10WRGB laser System: 1
2. Power cable: 1
3. User manual: 1
4. Emergency button for remote control
Technical parameters
1. Laser diode: DPSS, Green 532nm; Red 638nm; Blue 445nm
2. Power supply：AC110-240V, 50/60Hz
3. Power consumption: 200W
4. Laser power：Red 2W, Green 2W, Blue 6W
5. Scanners: high speed scanners DT40pro.
6. Control mode: Sound control/Auto/DMX/ILDA
7. Emergency button for remote control.
8. Dimensions: 425mm×380mm×420mm
9. Net weight: 25KG
10. Gross weight: 27KG (44KG with flycase)
DANGER
LASER RADIATION AVOID EXPOSURE
TO BEAM CLASS 3B LASER PRODUCT
----------------- 1 -------------------
list: