Doug Fleenor Design RERUN-R3 소유자 매뉴얼 - 페이지 2

{카테고리_이름} Doug Fleenor Design RERUN-R3에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Doug Fleenor Design RERUN-R3 12 페이지. Rackmount dmx512 recorder

PRODUCT DESCRIPTION

The Rerun Rackmount is a lighting control station capable of storing up to ten 40-minute shows on up to

4 universes. Shows are recorded by capturing the output of a DMX512 console. The recorded show start

and end points may be trimmed non-destructively. Each show can be set to hold the last look, loop to itself

or link to another show. Shows are started by pressing one of the ten show buttons.

The Rerun Rackmount can be built to support multiple universes of DMX512. As many as four universes

can be supported in a single 1U chassis. The Rerun-R1 supports 1 universe of DMX512, the Rerun-R2

supports 2 universes of DMX512, the Rerun-R3 supports 3 universes of DMX512, and the Rerun-R4

supports 4 universes of DMX512. Expansion units may be added via a 3-pin XLR connector on the rear

of the chassis in order to support additional universes.

The Rerun Rackmount occupies 1U of rackspace, and comes standard with rack ears for easy installation.

Also included is a clear security panel designed to block unintended button presses. Preset 10 remote

stations can be added to remotely select shows. Power to the Rerun Rackmount is provided by the

attached wall power supply.

The Rerun Rackmount system can work in conjunction with a lighting console, automatically switching

between recorded shows and console control. When the console generates DMX512, the Rerun

Rackmount retransmits the incoming DMX512 data. Thus the console operates normally. Upon loss of

DMX512 from the console, the Rerun Rackmount starts its previously active show.

Rerun also is available in an architectural version (model RERUN-A) and a portable version (model

RERUN-P). The Rerun Architectural and Rerun Portable units can each support one universe of DMX512

data.

Page 2 of 12