Doug Fleenor Design DMX24DIM 설치 및 운영 매뉴얼 - 페이지 3

{카테고리_이름} Doug Fleenor Design DMX24DIM에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Doug Fleenor Design DMX24DIM 5 페이지.
Doug Fleenor Design DMX24DIM에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (6 페이지)

페이지 인쇄

Power input (line) wiring

The DMX24DIM should be connected to a standard 15A 120VAC grounded outlet. The outlet must

be protected by an appropriate over-current protection device.

Note that if all outputs are loaded to 100W and all outputs are set to full, the 15A branch breaker

feeding the DMX24DIM or DMX24DIM-2U will trip. If the application requires all dimmers to be fully

loaded, the DMX24DIM or DMX24DIM-2U must be fed by a 20A branch breaker and an appropriate

receptacle. The standard 15A mains plug on the DMX24DIM or DMX24DIM-2U must be replaced

with an appropriate 20A connector.

Power output (load) wiring

Each output can supply a 100W (maximum) 120VAC load. Each output on the DMX24DIM uses a

polarized ungrounded parallel blade connector (NEMA1-15R). The DMX24DIM-2U uses grounded

parallel blade connectors (NEMA5-15). Cables should only be connected and disconnected while the

dimmer outputs are off or the input power to the unit is removed.

Control cable wiring

Standard 5 pin XLR cables should be used to connect DMX512 signals to the connectors on the front

panel of the DMX24DIM or DMX24DIM-2U. A male input is provided and a passive female "thru"

output is provided. There is no internal termination. The last device in the DMX512 daisy chain

should be fitted with a DMX512 terminator.

Only pins 1, 2, and 3 are used by the DMX24DIM or DMX24DIM-2U, however all 5 pins are passed

through to the "thru" connector.

Page 3 of 5