Doug Fleenor Design DMX24DIM 설치 및 운영 매뉴얼 - 페이지 3

{카테고리_이름} Doug Fleenor Design DMX24DIM에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Doug Fleenor Design DMX24DIM 6 페이지.
Doug Fleenor Design DMX24DIM에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (5 페이지)

페이지 인쇄

Power input (line) wiring

The DMX24DIM should be connected to a standard 15A 120VAC grounded outlet. The

outlet must be protected by an appropriate over-current protection device.

Note that if all outputs are loaded to 100W and all outputs are set to full, the 15A

branch breaker feeding the DMX24DIM will trip. If the application requires all dimmers

to be fully loaded, the DMX24DIM must be fed by a 20A branch breaker and an

appropriate receptacle. The standard 15A mains plug on the DMX24DIM must be

replaced with an appropriate 20A connector.

Power output (load) wiring

Each output can supply a 100W (maximum) 120VAC load. Each output uses a

polarized ungrounded parallel blade connector (NEMA1-15R). Cables should only be

connected and disconnected while the dimmer outputs are off or the input power to the

DMX24DIM is removed.

Control cable wiring

Standard 5 pin XLR cables should be used to connect DMX512 signals to the

connectors on the front panel of the DMX24DIM. A male input is provided and a

passive female "thru" output is provided. There is no internal termination. The last

device in the DMX512 daisy chain should be fitted with a DMX512 terminator.

Only pins 1, 2, and 3 are used by the DMX24DIM, however all 5 pins are passed

through to the "thru" connector.

Page 3 of 6