Baumer DENEX Gripper LED 사용자 설명서 - 페이지 12

{카테고리_이름} Baumer DENEX Gripper LED에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer DENEX Gripper LED 24 페이지.

To adjust the sensor to get a blocking of approximately 50 % do the following:

• Make a bracket that enables the sensor to be moved sideways, or order one from

Baumer. Specify type of conveyor!

• Set the sensor in Gripper Pulse Mode, see chapter 6.4

• Watch the Output LED during production. It should be flashing.

The next step can be dangerous! Watch your hands if you do the movement during

run!

• Move the sensor sideways until the Output LED is ON for approximately as long as it is

OFF to get 50 % duty cycle.

• You can also check with a scope, either on the Output directly or between TP8 and

TP1, see chapter 6.

If this is done OK, the sensor will only count one edge for half a Gripper, which will be the

ideal situation.

User Manual DENEX Gripper LED

Version 2013-02, V1.4

12/24

www.baumer.com

Baumer Electric AG

Frauenfeld, Switzerland