Dahua F Series 빠른 시작 매뉴얼 - 페이지 12

{카테고리_이름} Dahua F Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dahua F Series 18 페이지. Hd ir bullet network camera
Dahua F Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지), 빠른 시작 매뉴얼 (18 페이지), 빠른 시작 매뉴얼 (17 페이지), 빠른 시작 매뉴얼 (15 페이지), 빠른 시작 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (16 페이지), 빠른 시작 매뉴얼 (18 페이지), 빠른 시작 매뉴얼 (7 페이지), 빠른 시작 매뉴얼 (17 페이지), 빠른 시작 매뉴얼 (16 페이지), 빠른 시작 매뉴얼 (18 페이지), 빠른 시작 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (16 페이지), 빠른 시작 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (13 페이지), 빠른 시작 매뉴얼 (15 페이지)

Dahua HD Pinhole Network Camera Quick Start Guide

2 Device Installation

Note

All the installation figures below are for reference only due to the different models and

appearances. Please refer to the actual devices for exact details.

This product is a kind of separate device, and both the front end and the rear end of the device

have to be installed respectively. For front end, there are two types that are square and round,

and the square front end type has two installation ways.

Note

Please make sure the installation surface can support at least the 3X weight of the total weight of

the camera and the bracket.

The following figure shows the installation of round and square rear end:

Figure 2-1 Installation of round and square rear end

To install the round and square rear end, do the following:

1. Stick installation position map to designated surface where you will install the device.

2. Dig a hole according to position of hole on installation position map.

3. Open accessories bag, take out expansion bolt and insert it into the hole you just dug.

4. Open accessories bag, take out screws. Tighten the 3 screws to fix the device on the

installation surface where the bolts are located.

5. Put the camera body into the installation bracket directly.

6. Connect front-end lens to camera body by cable.