Dahua F Series Snelstarthandleiding - Pagina 12

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Dahua F Series. Dahua F Series 18 pagina's. Hd ir bullet network camera
Ook voor Dahua F Series: Snelstarthandleiding (17 pagina's), Snelstarthandleiding (18 pagina's), Snelstarthandleiding (17 pagina's), Snelstarthandleiding (15 pagina's), Snelstarthandleiding (6 pagina's), Snelstarthandleiding (16 pagina's), Snelstarthandleiding (18 pagina's), Snelstarthandleiding (7 pagina's), Snelstarthandleiding (17 pagina's), Snelstarthandleiding (16 pagina's), Snelstarthandleiding (18 pagina's), Snelstarthandleiding (12 pagina's), Snelstarthandleiding (16 pagina's), Snelstarthandleiding (12 pagina's), Snelstarthandleiding (13 pagina's), Snelstarthandleiding (15 pagina's)

Dahua HD Pinhole Network Camera Quick Start Guide

2 Device Installation

Note

All the installation figures below are for reference only due to the different models and

appearances. Please refer to the actual devices for exact details.

This product is a kind of separate device, and both the front end and the rear end of the device

have to be installed respectively. For front end, there are two types that are square and round,

and the square front end type has two installation ways.

Note

Please make sure the installation surface can support at least the 3X weight of the total weight of

the camera and the bracket.

The following figure shows the installation of round and square rear end:

Figure 2-1 Installation of round and square rear end

To install the round and square rear end, do the following:

1. Stick installation position map to designated surface where you will install the device.

2. Dig a hole according to position of hole on installation position map.

3. Open accessories bag, take out expansion bolt and insert it into the hole you just dug.

4. Open accessories bag, take out screws. Tighten the 3 screws to fix the device on the

installation surface where the bolts are located.

5. Put the camera body into the installation bracket directly.

6. Connect front-end lens to camera body by cable.