Baumer VeriSens CS Series 빠른 시작 매뉴얼 - 페이지 18

{카테고리_이름} Baumer VeriSens CS Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer VeriSens CS Series 44 페이지.

Instructions on commissioning of the Ethernet interface

To use VeriSens

The default factory configuration is:

1. If your network has an DHCP server, the IP address will request from that server.

You do not need any further manual adjustments.

2. If a valid IP address can not be determined within 15 seconds, the following

network configuration is used:

Default IP address: 192.168.0.250 (Subnet mask: 255.255.255.0)

My device is not located in the selection list after launching the

Application Suite ?

1. Check that the power cable of VeriSens

2. Make sure that your PC and VeriSens

3. Check the network settings of your PC, especially the IP address and

subnet mask. Contact your administrator possibly.

4. Make sure that each IP address is unique in your network!

18 18 EN

in your network, you must assign the device a unique IP address.

is connected correctly.

are connected in the same network.