Baumer VeriSens CS Series Посібник із швидкого старту - Сторінка 18
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Аксесуари Baumer VeriSens CS Series. Baumer VeriSens CS Series 44 сторінки.
Друкувати сторінкуInstructions on commissioning of the Ethernet interface
To use VeriSens
The default factory configuration is:
1. If your network has an DHCP server, the IP address will request from that server.
You do not need any further manual adjustments.
2. If a valid IP address can not be determined within 15 seconds, the following
network configuration is used:
Default IP address: 192.168.0.250 (Subnet mask: 255.255.255.0)
My device is not located in the selection list after launching the
Application Suite ?
1. Check that the power cable of VeriSens
2. Make sure that your PC and VeriSens
3. Check the network settings of your PC, especially the IP address and
subnet mask. Contact your administrator possibly.
4. Make sure that each IP address is unique in your network!
EN
18 18 EN
®
in your network, you must assign the device a unique IP address.
®
is connected correctly.
®
are connected in the same network.