Baumer AMG11 N29 매뉴얼 - 페이지 19
{카테고리_이름} Baumer AMG11 N29에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer AMG11 N29 41 페이지. Absolute encoders with profinet interface
페이지 인쇄
4.5. Topology planning
It is obligatory to plan the topology in order to perform IRT Class3 and / or to utilize the system feature
"Device replacement without exchangeable medium". Port connections and cable lengths between all system
components are made known to the project. In this way the project tool is enabled to consider cable-, port-
and switch delay times and to optimize overall performance.
Enter Topology Planning e.g. by right-clicking the PROFINET bus rail in the Hardware window of Step7
software, which opens the following pull-down menu.
The Graphic View clearly shows port assignment of all bus components. The assignment made here must fit
to the real conditions.
In the example below, controller port1 is linked to port 1 of the encoder. The programming tool (PG/PC) is
connected to port 2 of the controller.
Baumer_BUDE-PROFINET_MA_EN.docx
19/41
www.baumer.com
14.06.2016 / bja