Electric Eel eCAM ACE 2 SL 운영자 매뉴얼 - 페이지 14
{카테고리_이름} Electric Eel eCAM ACE 2 SL에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electric Eel eCAM ACE 2 SL 20 페이지. Video inspection system
페이지 인쇄INSPECTION PROCEDURE
Skids or sleeves should ALWAYS be used to protect the camera head. De-
pending on the size of the pipe you are inspecting, you may need to use a
skid, so the camera is centered or off the floor of the line. Care should be
taken so the skids do not snag in the line.
Under normal operating situations, the camera is used with a smaller protec-
tive sleeve in lines under 4" in diameter or a larger grooved skid in 4" lines
and larger.
1.
Slowly push the camera into the pipe and negotiate the camera into
position to feed down the pipe making sure the flex neck does not
kink or double back on itself.
2.
Push the camera slowly and carefully during the inspection taking
note of the pipe condition for possible hazards that may entangle or
damage the camera on entry or retrieval.
3.
When negotiating a corner, care should be taken not to butt the nose
of the camera against the sidewall with any force. It would be better to
let the camera "work" its way around the corner. If resistance is en-
countered when turning the corner and there are no visible signs of
blockage, turning the push rod or pulling the camera back and forth
sometimes helps
4.
Should resistance become extreme, or the camera get entangled or
stuck, slowly push it back and forth to free it. Sometimes turning the
push rod may also help. If the camera is visible, you may be able to
free it with your hand or some other means.
5.
Upon completion of the inspection and retrieval of the camera, it may
be necessary to 'manipulate' the camera around the initial bend (clean
out) in the pipe with a pole or other device if required.
6.
NEVER use the camera to unclog a drain or clear debris in the pipe.
Doing so can cause damage to the camera head or lens.
7.
NEVER force the camera down a pipe as this may cause a kinked
cable which will require expensive repairs.
8.
NEVER use a pressure washer to clean any part of the system. High
pressure water can cause degradation of the electronic parts causing
damage.
9.
NEVER unspool all of the rod from a reel. Always leave a few turns
of rod on the reel to aid with respooling.
14