Baumer Hubner Berlin PMG10 운영 매뉴얼 - 페이지 24
{카테고리_이름} Baumer Hubner Berlin PMG10에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer Hubner Berlin PMG10 44 페이지. Absolute encoder
Baumer Hubner Berlin PMG10에 대해서도 마찬가지입니다: 설치 및 작동 지침 (32 페이지), 설치 및 작동 지침 (32 페이지)
페이지 인쇄
6
|
Electrical installation
6.8
Electrical connection with radial terminal boxes
6.8.1
Connecting the supply cable
NOTICE
Equipment damage due to dust or moisture
Inappropriate cable diameters may entail ingress of dust or moisture. In this case, the protection
class is no longer ensured causing device failure or malfunction.
a) Use only appropriately sized cables to make sure the specified protection class is being en-
sured.
INFO
Connection cables are not included in delivery.
1
6
Ill. 10: Connecting the supply cable
1
3
5
Tools
t20
n
n
Instruction:
a) Loosen the screws at the terminal box.
b) Lift the terminal box off the encoder.
c) Loosen the cable gland at the terminal box.
24
2
3
Torx / slotted screw M4x32 mm
Terminal connector (wire cross-section
2
≤ 1.5 mm
)
Additional incremental output (optional),
speed switch (optional), programming
interface (PMG10P only)
Supply cables (cable diameter 5-13
mm)
22 mm
Operating Manual
5
2
4
6
4
Terminal box cover
Cable shield
Cable gland M20x1.5 mm (for cable di-
ameter 5-13 mm)
PMG10 & PMG10P SSI | V1
Baumer Hübner