Baumer HUBNER BERLIN PROFI NET microGen HMG10P 운영 매뉴얼 - 페이지 18
{카테고리_이름} Baumer HUBNER BERLIN PROFI NET microGen HMG10P에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer HUBNER BERLIN PROFI NET microGen HMG10P 44 페이지. Incremental encoder with magnetic sensing
Baumer HUBNER BERLIN PROFI NET microGen HMG10P에 대해서도 마찬가지입니다: 설치 및 작동 지침 (32 페이지), 설치 및 작동 지침 (40 페이지)
페이지 인쇄
5
|
Installation
1
Blind hollow shaft or cone shaft with
wrench flat SW 17 mm
3
Torx/slotted head screw M4x10 mm (DIN
7964)
5
Spring washer 6 (DIN 7980)
7
Torque arm
9
Cheese-head screw M6x8 mm for
grounding strap (ISO 1207)
11 Washer B6.4 (ISO 7090)
13 Self-locking nut M6 (ISO 10511)
15 Threaded rod M6 (variable length ≤ 210
mm)
Tool
5 mm
n
n
20 mm
n
1,6×8 mm
n
Measuring gauge
n
Instruction:
a) Verify drive shaft about any concentricity error (see further links).
b) Mount the encoder in a way ensuring the electrical connection is protected against water
ingress.
c) Loosen the encoder cover.
d) Apply grease onto the drive shaft.
e) Mount the encoder using cheese-head screw and spring washer. For doing so, tighten the
screw with a torque of 3-4 Nm and secure with wrench if necessary.
18
16
15
11
10 mm, 17 mm
Operating Manual
1
14
13
12
10
9
8
7
6
2
Cover
4
Cheese-head screw M6x30 mm (ISO
4762)
6
Self-locking nut M6 (ISO 10511)
8
Washer B6.4 (ISO 7090)
10 Washer B6.4 for grounding strap (ISO
7090)
12 Washer B6.4 (ISO 7090)
14 Grounding strap
16 Self-locking nut M6 (ISO 10511)
2
3
5
4
HMG10 & HMG10P EtherNet/IP | V1, T1
Baumer Hübner