Douglas Dynamics SnowEx HDV 77780 설치 지침 매뉴얼 - 페이지 6
{카테고리_이름} Douglas Dynamics SnowEx HDV 77780에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Douglas Dynamics SnowEx HDV 77780 16 페이지. Snowplow
페이지 인쇄T‑FRAME HOLE POSITION
IMPORTANT! Before assembling headgear to
T‑frame, measure the vehicle mount height to
confirm whether standard receivers or tall receivers
are required, and which T‑frame and headgear holes
to use for installation. (If the vehicle is not available,
use the Position 2 holes on headgear and T‑frame.
Make adjustments later.)
Before measuring the vehicle mount height, the mount
must be installed on the vehicle, ballast (if required)
must be installed, and the vehicle must be parked on a
level surface.
1. Measure the distance "d" from the ground to the
center of the hole in the vehicle mount. Measure
the distance on both sides of the vehicle and
determine average value for "d".
d
2. Use the following table to determine the proper
hole positions.
Hole Position
Headgear
Distance "d"
Hole Position
11.5" – 13.0"
13.0" – 14.5"
14.5" – 16.5"
16.5" – 18.5"
†
Tall receivers (85121 & 85122) required in place of standard
†
receivers.
T-Frame
Lit. No. 52592, Rev. 04
INSTALLATION INSTRUCTIONS
Center of Hole
in Vehicle Mount
T‑Frame
Hole Position
2
1
2
2
1
2
1
2
2 1
Headgear
2
1
T‑FRAME TO HEADGEAR
1. Position the T‑frame between the headgear strut
and inner ear, aligning the appropriate T‑frame
and headgear holes selected from the Hole
Position table.
2. On each side, insert 1" x 4‑3/4" clevis pins (from
the shipping bracket) from the outside of the
headgear through the correct T‑frame holes.
Secure the clevis pins with 1" flat washers and
1/4" x 1‑1/2" cotter pins found in the parts bag.
1" x 4-3/4"
Clevis Pin
Select holes
based on
distance "d".
3. Fold the headgear forward and pin the lift cylinder
to the T‑frame using a 5/8" x 4‑1/4" clevis pin and
1‑1/2" x 5/32" cotter pin from the parts bag.
6
Strut
Inner
Ear
1" Washer
1/4" x 1-1/2"
Cotter Pin
July 15, 2020