Baumer PMG10P 설치 및 작동 지침 - 페이지 14

{카테고리_이름} Baumer PMG10P에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer PMG10P 36 페이지. Absolute encoder
Baumer PMG10P에 대해서도 마찬가지입니다: 설치 및 작동 지침 (32 페이지), 설치 및 작동 지침 (32 페이지), 운영 매뉴얼 (44 페이지), 운영 매뉴얼 (44 페이지), 운영 매뉴얼 (40 페이지), 운영 매뉴얼 (40 페이지), 운영 매뉴얼 (40 페이지), 운영 매뉴얼 (36 페이지)

MOUNTING

4.3

Maximum permissible mounting tolerance when the Baumer Hübner K 35 spring

disk coupling is used

Devices with a solid shaft should be driven through the Baumer Hübner K 35 spring disk

coupling (accessory), that can be pushed onto the shaft without axial loading�

The figure below shows the device with EURO flange B10, the same maximum

permissible mounting tolerances are valid with housing foot B3�

)

The device must be mounted on the drive with the least possible angular error and

parallel misalignment�

)

Risk of damaging the ball bearings

Coupling components must not be driven onto the shaft with improper force (e� g�

hammer impacts), because of the risk of damaging the ball bearings�

max

Admissible

parallel misalignment

* With insulated hub

All dimensions in millimeters, unless otherwise stated�

11/29

= 10 N

2-10

Admissible

angular error

MB245EN - 11171693, 19A3, Baumer_PMG10-SSI_II_EN

Admissible

axial movement

±0.7 (±0.3*)