Douglas Dynamics SnowEx Automatixx SPEEDWING 77740 설치 지침 매뉴얼 - 페이지 12
{카테고리_이름} Douglas Dynamics SnowEx Automatixx SPEEDWING 77740에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Douglas Dynamics SnowEx Automatixx SPEEDWING 77740 17 페이지.
페이지 인쇄
OPERATIONAL TEST AND FINAL ADJUSTMENTS
CABLE ADJUSTMENT
1. Angle the blade fully left and inspect the area
between the driver-side wing stop and the
driver-side blade rib.
Grease
Fitting
2. If there is a gap between the wing stop and the rib,
skip to Step 3.
If there is no gap, return the blade to the straight
position and loosen the 3/4" jam nut and 3/4" hex
nut on the end of the cable 1/4 turn. Repeat this
adjustment until a gap can be seen.
Lit. No. 52308, Rev. 06
3. Return the blade to the straight position and adjust
4. Continue making this adjustment until the wing
Rib
Wing Stop
12
the hex nut 1/4 turn clockwise. Angle the blade
fully left and inspect the area between the wing
stop and the rib again.
stop just contacts the rib when the blade is fully
angled left.
Wing stop must just contact
rib when blade is fully angled.
Rib
May 1, 2021